Introducing... The Conic-All System™
Patented

The CONIC-ALL is a 30 degree one piece beveled end cap available in smooth or embossed .020 aluminum or .016 stainless steel from 2.88 through 30.0 outside diameter. When terminating or changing diameters in aluminum or stainless steel jacketed insulation systems, use CONIC-ALLS.

As with standard flat end caps you order the outside diameter required. The inside diameter is cut in the field. Pre-scribed graduated radial lines (type l) or graduated increments (type ll) from ½ inch IPS through 30.0 diameter are displayed on each CONIC-ALL (see illustrations below ). This feature makes cutting the inside diameter a very fast procedure, and will fit all inside diameters.


CONIC-ALLS present a neater appearance, easier fit, and require half the labor to install than the standard flat end caps, and they give professional looking beveled access to nuts and bolts at flanges and valves for maintenance purposes.

Competitive unit pricing makes the CONIC-ALL an attractive overall cost saving alternative to standard end caps. The Comparative Analysis below describes the CONIC-ALL one-piece labor saving installation procedures compared to 2-piece flat end caps.

Procedures required for installing 1-piece CONIC-ALL (Type I)

Procedures required for installing 1-piece CONIC-ALL (Type II)

Procedures required for installing 2-piece flat end caps

1. Procure necessary outside diameter CONIC- ALL.

2. Determine inside diameter

3. Cut on appropriate displayed line (See illustration below)

4. Pull off tab and install 1-piece CONIC-ALL.

1. Procure necessary outside diameter CONIC-ALL.

2. Determine inside diameter.

3. Set dividers at apex hole and at required inside diameter increment (See illustration below)

4. Scribe your own line.

5. Cut on line.

6. Pull off tab and install 1-piece CONIC-ALL.

1. Procure necessary outside diameter end cap set.

2. Determine inside diameter.

3. Convert inside diameter to inside radius.

4. Pull out tape measure and set dividers at inside radius.

5. Scribe line on first half.

6. Scribe line on second half.

7. Cut line on first half.

8. Cut line on second half.

9. Install first half.

10. Install second half.